How to use wah on my s90

[CS-2X]

Hi Guys, I'm currently working on a monster lead on my (Yamaha) s90, and so far, I'm pretty happy with the results, but the only problem is..... I don't know how to assign a wah effect to my modulation wheel. There's no effect for this (only auto wah and touch wah :? ). I've tried some filter effects, but they didn't work either (I'm not very familiar with programming, so... :roll: ). do you guys no how to do this?

[Enigma™]

well, I'm assuming that the auto-wah is an effect that is non configurable and the touch wah, I don't know how it works. If the touch wah is basically attached to how hard you hit the keys, then it SHOULD be attachable to the mod wheel. I don't know enough about the S90 to tell you though :(

[PsawniK]

Try setting the Sens parameter on the Touch Wah effect to 0 and then setting the mod wheel or an expression pedal to increase the sensitivity. Also try doing this with the Cutoff parameter. Make sure you run the wah into distortion, not the other way around.

Another way to do it is using the master lowpass filter (where the four sliders are). Set up your patch, and then lower the Cutoff slider to -64. Raise the Resonance slider to about +15 (higher or lower depending on how much wah you want), and then set up a controller to sweep the cutoff.

When your done, could you post your patch? I haven't seen any other S90/Motif users other than Sol with which to trade patches.